Skutt KS Kiln Unpacking - Manual (Page 2)

TA
B T
EX
T H
ER
E
TA
B T
EX
T H
ER
E
TA
B T
EX
T H
ER
E
TA
B T
EX
T H
ER
E
TA
B T
EX
T H
ER
E
REP
AIRS
PARTS INSTRUCTION SHEET
13.2 REV 05/20/05
KS KILN UNPACKING INSTRUCTIONS CONTINUED
Page 2 of 2
Option two
1. Remove the screws that secure the left side of each slave box to the side of the
kiln. Slave boxes are the boxes without the Kiln Sitter.
2. Swing the box or boxes open on their hinge.
3. Slide the 2 black lead wires off the heat switch of each slave box.
4. Disconnect the ground wire on each box by removing the wing nut and lock
washer that secure them. (Save these you will need them when you put it
back together.)
5. Release the section latches on the side of the kiln.
6. Remove each section and place them on a clean, flat surface.
7. Position the kiln floor on top of the stand making certain that the weight is
evenly distributed.
Notes on assembly. Make sure the stand and kiln floor are level and do not
teeter. Leveling problems may put unnecessary stress on the kiln during
firing. To level the stand, place firm shims under the legs (never above
them touching the kiln). Center the kiln’s bottom slab on the stand and
double-check teetering.
8. One at a time, stack the sections on the kiln floor.
9. Secure the section latches.
10. Reconnect the ground wire on each slave box with the wing nut and lock
washer you saved
11. Slide the lead wires back on to the heat switch. These wires are interchange-
able.
12. Close and secure each slave box with the screws you saved.
13.Replace the lid and lid hardware if it was removed in step 7.
The kiln is now ready for use. Please read your manual.