Smithco Super Star Diesel 43-500 (sn 14560 – 14579) Parts & Service Manual - Manual (Page 6)

4
Service
MAINTENANCE
Before servicing or making adjustments to machine, stop engine and remove key from ignition.
Use all procedures and parts prescribed by the manufacturer's. Read the engine manual.
LUBRICATION
Use No. 2 General purpose Lithium Base Grease and lubricate every 100 hours. The Diesel Super Star has five
grease fittings. One is located on the foot pedal. One located on the steering cylinder, two on the rake lift and
one is located on the steering chain tensioner. Access to the steering chain tensioner is available through the
plugs located on the right side of the nose cone.
REMOTE AIR CLEANER
1. Un-clip the two clips, remove the cover and pull out the element.
2. To service, clean by tapping gently on flat surface. Do not oil. Replace if very dirty or damaged.
3. Clean out the inside of the body and cover.
4. Place the element into the body and put the cover back on.
TOWING
When it is necessary to move the Super Star without engine running, bypass valve built into hydrostatic pump
must be "open" by turning it counterclockwise. The valve is located on the right side of the pump. An "open"
valve allows fluid to pass through the wheels freely. When normal, driven, operation is desired, valve should be
"closed by turning it clockwise. Failure to "close" the valve with engine running means no power to wheels. The
machine can be moved for a short distance with the engine off, but we do not recommend this as a standard
procedure. When towing do not tow the machine faster than 2-3 MPH (3-5 km/h) because the drive system may
be damaged. The tires may lock up if the machine is towed too fast. If this occurs, stop towing the machine. If
the machine must be moved a considerable distance, transport it on a truck or trailer.