SONOSAX SX-ES64 - Manual (Page 11)

User manual SONOSAX SX-ES64 Page 11 of 27
4.1.10 Pre-Fader Listening [PFL]
The [PFL] functionality - Pre-Fader Listening - is used to isolate and listen to the channel's modulation before
the fader. Thus, the settings of the channel such as the input gain, EQ and LF Cut can be adjusted precisely,
without being affected by listening to other channels. Multiple channels can be summed in PFL mode.
Once a PFL is activated, the modulation of the corresponding channel becomes audible in the headphone
outputs of the primary monitoring instead of the current selection, and its level is displayed on the secondary
modulometer instead of Masters 3 & 4. The PFL is signalled by the Yellow LED at the bottom left side of the
secondary modulometer.
When PFL is disabled, the monitor and the secondary modulometer return to their previous selection
NOTE:
By default, the pre-listening is PRE-Fader (PFL), an internal solder jumper can change this
function to AFTER-Fader Listening (AFL) (please specify when ordering). AFL modulation is
taken before the PAN.
4.1.11 Channel fader
A high quality, plastic conductive, 100mm linear fader allows precise control of the signal level sent to the mix
busses 1 to 4 and also to the direct channel output if set to post-fader.
The fader has a logarithmic course with a scale graduated in decibels on both side on the cursor. The fader
range goes - infinite to +12 dB.