SP Controls SP3-AFVP+ - Manual (Page 2)

Important Safety Instructions
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with a dry cloth.
7) Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or grounding type plug. A polarized plug has two
blades with one wider than the other. A grounding type plug has two blades and a third grounding
prong. The wide blade or the third prong is provided for your safety. When the provided plug does not fit
into your outlet, consult an electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched particularly at plugs, convenience recepta-
cles, and the point where they exit from the apparatus.
11) Only use attachments/accessories specified by the manufacturer.
12) Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid
injury from tip-over.
13) Unplug this apparatus during lightning storms or when unused for long periods of time.
14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been
damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate
normally, or has been dropped.
WARNING - To Reduce the Risk of Fire Or Electric Shock, Do Not Expose This Apparatus
To Rain Or Moisture.
Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids,
such as vases, shall be placed on the apparatus.
FCC Compliance
This equipment generates radio frequency energy and if not installed in accordance with the manufac-
turer's instructions may cause radio interference.
This equipment complies with part 15, Subpart J of the FCC rules for a Class A computing device. This
equipment also complies with the Class A limits for radio noise emission from digital apparatus set out in
the Radio Interference Regulation of the Canadian Department of Communications. These above rules
are designed to provide reasonable protection against such interference when operating the equipment
in a commercial environment. If operation of this equipment in a residential area causes radio frequency
interference, the user and not SP Controls, Inc., will be responsible.
Changes or modifications made to this equipment not expressly approved by SP Controls, Inc., could
void the user's authority to operate the equipment.
email : [email protected]
web: spcontrols.com
phone: (877) 367-8444
SP Controls Inc.
930 Linden Ave.
S. San Francisco, CA 94080
Page 2