Tascam MMR-8 - Manual (Page 27)

MMR-8 TASCAM MMR-8 Owner’s Manual • Chapter 2 • Installation 27
PARALLEL TRACKS
ANALOG IN
AUXILIARY OUTLET
115/230~VAC 1/0.5 A
MMR-8
MODEL NO.
2.0 / 1.0 A,
TEAC CORPORATION
MODULAR MULTITRACK RECORDER
115 / 230 ~,
SERIAL NO.
230 W UL1950
LISTED
E177247
50 - 60Hz
MADE IN USA
14DK
R
OUT
WORD CLOCK
IN
BLANK
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING RESTRICTIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
ANALOG OUT
BOB
REMOTE
OUT
VIDEO
IN IN OUT
MIDI
MAY CAUSE UNDESIRED OPERATION.
DIAG
THRU
TIME CODE
IN OUT
NET SCSI M 2 BLANK BLANK
ADIF
1-8
LYNX EDITOR TRANSPORT
PARALLEL TRANSPORT
MMR-8 Back Panel Connections For Serial # 01609 And Above
MMR units with serial numbers starting at 01609 and higher have a different arrangement for back panel connectors than previous units. The arrangement
of connectors for serial numbers 10609 and above are shown in the drawing above and are listed here.
•
Analog audio in
•
Analog audio out
•
AES Digital audio I/O (labeled ADIF 1-8)
•
Biphase In (BOB)
•
Biphase Thru (BOB)
•
Mono mix audio out (M2)
•
SCSI
•
Remote control
•
MMR bus (M2)
Not intended for public
telecommunication
network
•
Word clock in
•
Word clock out
•
Video sync in
•
Video sync out
•
Midi in
•
Midi out
•
Midi thru
•
Time code in
•
Time code out
•
Diagnostic port (service tech only)
•
Lynx (2 connections)
•
Editor (Sony 9-pin in)
•
Transport (Sony 9-pin out)
•
Parallel Tracks
•
Parallel Transport
•
Network (for OPTIONAL 100Mbit
Ethernet)
MMR-8 Back Panel for Serial Numbers 01609 and above