Teac KS-6001 User Manual
Page 10
10
KS-6001
If this (and/or the equivalent indicator on the KS-342) flashes
read, you should immediately replace the batteries.
Using the unit—some notes
Before starting to use the KS-6001, or connecting any equip-
ment to it, make sure that the unit’s power switch is turned
OFF.
Before actually connecting microphones or other sources to it,
make sure that the input selector switch is turned to the appro-
priate position for each channel. There is a risk of serious dam-
age to equipment if the wrong selection is made!
Make the multi-pin output/power connection.
Turn on the power when the connections have been made.
The unity gain position for each fader is around the 2 o’clock
mark, as shown by a slightly thicker line at this position.
Typically, you should set the individual channel faders to this
position, the master controls to their maximum, and then ad-
just the trim controls so that the VU meters on the main mixer
to which the KS-6001 is connected show 0 dB on a nominal sig-
nal input. This provides sufficient headroom without forcing the
head amp to work too hard.