Tech Source GFX 400 Series - Manual (Page 15)

Chapter 3 – Software Installation
3-3
2.
Boot the computer with the "-r" (reconfiguration) option.
To do this on a typical SPARC desktop/server, perform
the following steps:
•
Power ON the computer.
•
Wait until you see boot messages displaying on the
screen, then press and hold the Stop (L1) key, and
then press the "A" key.
•
At the "ok" prompt, type "boot –r" followed by the
<Enter> key.
3. After the system has booted, log in as root.
4.
Insert the CD-ROM labeled "GFX 400 Series Driver
Software-Solaris Edition" into the CD-ROM drive.
5.
If /cdrom/cdrom0 exists, type:
prompt# cd /cdrom/cdrom0
Skip to step 6. Otherwise, mount the CD-ROM by typing
the following:
prompt# mount -F hsfs -O -o ro \
/dev/dsk/c0t6d0s0 /cdrom
prompt# cd /cdrom
6.
The CD-ROM contains an install_all script. To
install the software, type:
prompt# ./install_all
This script will ask you a number of yes-or-no questions
(generated by Sun's pkgadd install script). Answer
these questions appropriately.
7.
Reboot the system to complete the installation.