Desa (F)SVYD18N - Manual (Page 10)

10 104461
VENT-FREE NATURAL GAS STOVE HEATER
DESA INTERNATIONAL
INSTALLATION
Continued
Figure 13 - Attaching Stove Door (Appearance May Vary Depending on Model)
Step
Bolt
Door
Hinge
Threaded
Hole
Stove
Door
Stove Bottom Bolt
Shoulder
Door
Hinge
Step
Bolt
Bolt
Shoulder
Adjusting Nut
Bolt Stop
Catch Bolt
Door Claw Door
Figure 14 - Catch Bolt and Door Claw Orientation
Stove
Door 10. Attach stove door by inserting step bolt
through door hinge pivot hole and into
threaded hole in stove body (see Fig-
ures 8 and 13). Use an adjustable
wrench or a 12mm socket to fasten step
bolt. Tighten step bolt until snug. Make
sure door moves freely.
11. Install door catch bolt (M8 x 1.25-
55mm with two M8 hex nuts) into
threaded hole on stove body (see Fig-
ure 8, page 9). Use an adjustable
wrench or a 12mm socket. The catch
bolt has two hex nuts attached to it (see
Figure 14). The top nut is a bolt stop
and the bottom nut is for door leveling
adjustment.
12. Check general catch bolt alignment
with door claw. Make final adjustment
and door leveling after stove is in nor-
mal standing position.
13. Carefully lift stove back up on its four
attached legs.
14. Set top grate into stove top.
15. If available, install gas log heater in-
side stove cavity before installing the
back panel (see Installing Gas Log
Heater Into Stove, page 11).
16. Fasten back panel to stove with six (6)
M6 x 1 - 20mm bolts and washers.
Make sure product identification label
is located on the outside in lower left-
hand corner.