D-Link DVS-301 - Manual (Page 14)

Building Networks for People
DVS-301 User Manual v1.00
8
Software configuration
Easy way with installer program
In order to configure Video Servers remotely, administrators should keep the MAC address of
the new Video Servers for identification and initial passwords. After successfully mounting
Video Servers in the proper position, run the Installer program on the appropriate PC to locate
the newly installed Video Servers. Video Servers also support manual setup procedures to
non-Windows based environments. The manual procedure is described next.
After the POST is done, Video Server will try to configure itself by detecting the network
environment. If there is DHCP service over the network, the Installer program will catch the
given information and display the serial number and given IP address for each Video Server as
following figure. If no DHCP service is available, a previous IP address will be displayed instead.
In that case, it may be 0.0.0.0 for a brand new unit. When multiple units are mounted, there may
be several entries shown in the window. Administrators may click on each entry with "Assigned"
field labeled "No" to install sequentially.