Tri Tool 208B Flange Facer - Manual (Page 11)

11
Model 208B FF (Flange Facer)
92-1495 : Orig. 100728
Location of the Various Screws
Hold Down
Screws
Adjustment Set
Screws
Feed Sprocket
Tighten the hold down screws to about 12 in/lbs (1.4 Nm) to 24 in/lbs (2.7
Nm); Finger tighten using a hex key.
Using the 1/4" drive ratchet, run the tool holder to the inward most position.
Note any changes in the feed pressure.
Some drag from the slide rails should be felt, but only a very light torque
should be required to move the tool holder.
Adjust the remaining adjustment set screws so that the tool holder has a
smooth, even feel.
Run the tool holder the full length of the slide rail.
Tightly lock the adjustable slide rail in place with the hold down screws and
fully snug the adjustment set screws.
Check that the tool holder runs smoothly and evenly for the full length of travel.
Readjust as necessary.
Check the position of the Tool Bit to the Flange.