Tri Tool 224B Miter Mandrel - Manual (Page 15)

15
Org 990702
Model 224B Miter Mandrel Head
Check the gap between the Gimbal Plate and the Mandrel Head to see that it is
approximately even all around.
Uneven gap
Angular Offset Adjustment Screw (4)
Draw Screw
Draw Nut
Torque Pin (4)
Angular offset pivot point
Angular Offset Adjustment.
NOTE:
If it is not, then loosen the angular offset adjustment screw(s) where the gap is small
and tighten the Angular Offset Adjustment Screw(s) where the gap is wide.
Lightly tighten the Draw Nut.
All four of the Angular Offset Adjustment Screws must be used in conjunction with
each other.
All screws must be at least slightly loose to allow movement.
If the Mandrel Shaft is to be drawn directly toward one screw, the opposite screw
must be loosened far enough to allow for the take up before the near screw is
tightened.