Tri Tool 224B Miter Mandrel - Manual (Page 17)

17
Org 990702
Model 224B Miter Mandrel Head
NOTE:
It is highly desirable to mount the Miter Head so that the Angular Offset Pivot point
is on the same plane with the proposed finished wall preparation.
This will diminish the amount of parallel offset required after the angular adjust-
ment has been made.
Using a tape measure or steel rule, keep the rear flange of the Gimbal Plate roughly
centered while turning the Jackscrews to tighten them against the ID of the
workpiece.
Use the wrenches provided to tighten all (8) eight Jackscrews securely.
Mount the Indicator Sleeve to the Adaptor Plate Assembly and tighten the Mount-
ing Nut.
Place the Magnetic Based Indicator Holder onto the Sleeve and energize the mag-
net.
Instillation of the Indicator Sleeve Assembly.
Final Face Line
Angular Offset
Pivot Point
Adaptor Plate
Assembly
Mounting
Nut
Indicator Sleeve
Assembly
Workpiece