Tri Tool 302 Tube Squaring Micro Feed Assembly - Manual (Page 6)

6
TRI TOOL INC.
92-0710 : Rev. 040218
INSTALLATION
REMOVING THE LEVER FEED ASSEMBLY
In order to install the micro-feed assembly onto the back of the Model 302, the
existing lever feed assembly must be removed.
Remove the two (2) cap screws from the back of the cover.
Remove the cover from the lever feed assembly.
Remove the Button head screw and capture washer from the end of the feed shaft.
Remove the four (4) cap screws from the flange on the lever feed system.
The lever feed assembly may now be removed.
The ball bearing on the end of the feed shaft may come off if it is loose, otherwise
leave it in place.
Feed Shaft
Main Housing
Ball Bearing
Cap Screw (4)
Cap Screw (2)
Cover
Capture
Washer
Button
Head
Screw Lever Feed System