Tri Tool 302 Tube Squaring Micro Feed Assembly - Manual (Page 7)

7
Micro-Feed Assembly for the 302
92-0710 : Rev. 040218
PREPARE THE MICRO-FEED ASSEMBLY
Loosen the set screw from the feed handle.
Remove the feed handle from the micro-feed assembly.
Remove the lock knob from the end of the feed shaft.
Remove the thrust washer and the spring washer from the end of the feed shaft.
Remove the indicator dial from the feed shaft.
Remove the four (4) cap screws from the feed cover.
Rotate the feed screw to remove the feed cover and the feed screw from the back of
the feed adapter.
INSTALLING THE MICRO-FEED ASSEMBLY
The ball bearing in the front of the feed adapter is the same as the one in the back
of the Model 302 main housing.
Only one ball bearing is required, remove the one or the other.
Spring
Washer
Thrust
Washer
Feed Adapter
Feed Cover
Indicator Dial
Feed Handle
Cap Screw (4)
Lock Knob