DYSON CRO2 - Manual (Page 8)

600 mm
MAX. 450 mm
MIN.
848 mm
595mm
Dimensions Height 848mm Depth 575mm Width 595mm
Weight: 103kg.
Voltage: 220-240V, 50Hz. Please refer to rating plate
(see section 01 for location).
Power: 2750W 230V. Please refer to rating plate
(see section 01 for location).
Water pressure: 0.4-5 bar.
Capacity: 7kg dry laundry maximum.
Location
Every Dyson washing machine is tested before it leaves the
factory. As a result, there may be some dampness or water in
the machine.
• The machine should not be installed in a location where the
temperature may drop below freezing.
• The machine should not be installed in a bathroom.
• The machine must be installed on a secure and flat surface.
Soft floors, such as carpet or carpet tiles, are not suitable.
The layout of the drainage taps and power socket and their
distance from the machine are illustrated below. The water
inlet hoses, drainage hose and electrical mains lead must be
positioned carefully to avoid damage or kinks when the
machine is in use. The machine can be connected to a
standpipe, under-sink pipe connection or other drainage
system, but the critical dimensions must be adhered to.
Important
1
1
Specification
Installation
Drainage using an under-sink pipe*
Drainage, water supply and electricity
The washing machine comes with:
2 inlet hoses
1 drainage hose hook
1 Dyson spanner
1 drainage hose at the back of the machine
The above items are found in the drum unless stated otherwise.
5 01
600 mm
MAX.
450 mm
MIN.
Drainage using a stand pipe*
Cold inlet hose
Hot inlet hose
Drainage hose hook
Note: Hoses can be supplied in 2.5m lengths if required. Please contact the helpline to order.
Dyson spanner
8887_CRO2_OPS_INNERS.qxd 5/11/03 3:26 pm Page 6