Upsite 10123 2 Post Rack Grommet - Manual

Carton Contains:
Part No. 20170 Brush Holder Mounting Extrusion (2)
Part No. 20172 Sealing Brushes (2)
Part No. 20171 End Caps (2)
2 Post Rack Grommet
Part Number
10123
Installation Guide
Installation instructions
2 Post Rack Grommet
1. Slide brush into plastic extrusion (2X).
2. Center brush in plastic extrusion (2X).
3. Slide brush assembly onto rack supportflange (2X).
4. Slide end cap hooks into plastic extrusion channels (2X).
SAFETY REQUIREMENTS
Installers must be familiar with standard safety and risk
management practices when working in raised-floor environments
and when modifying floor tiles.
Effective Installation of Cables
In order to minimize any air loss from the rack hole selection,
make sure to allow for adequate slack in the cables. If the cables
are under too much tension, the grommet may be pulled apart,
resulting in a gap that will cause an increase in the flow of air
escaping through the rack.
End cap hooks
connect into
extrusions
Installation
complete
Top view
after brushes
are installed
1
3
4
2