Venstar T1100RF - Manual (Page 12)

Press
MODE
Press
py
O
co
Tu
If Yes is selected:
If No is selected:
(Unit # 1 only) Programming a Daily Schedule
The copy command becomes available after
programming the entire previous day.
Selecting Yes, then pressing MODE will
copy the previous day’s program. If yes
is selected again, or each time, this
routine will repeat.
If No is selected, as in previous steps, flashing prompts for
input will appear for the four time periods for the next day.
After programming for all seven days is complete, press
the MODE and UP buttons at the same time for two seconds
to leave the Setup screens. If no buttons are pressed, the
display will leave the setup screens after 30 seconds.
MODE
Page 11
Select Yes to copy the
previous day’s program
to the day displayed.
Yes
No
MODE