Venstar T1100RF - Manual (Page 18)

HEAT/COOL DIFFERENTIAL - The Heat and Cool setpoints will not be
allowed to come any closer to each other than the value set in Advanced
Setup step #7, on page 13. This minimum difference is enforced during
Auto-changeover and Program On operation.
Note: To increase the spread between the heating and cooling setpoints,
press the MODE button until only the heat setpoint is displayed; adjust to
the desired setpoint. Press the MODE button until only the cool setpoint
is displayed; adjust to the desired setpoint. Press the MODE button again
to enter the Auto-changeover mode where both the heat and cool
setpoints are displayed.
About Advanced Features & Operation
WARNING: This will reset all Time Period and Advanced Programming to
the default settings. Any information entered prior to this reset will be
permanently lost.
FACTORY DEFAULTS -
settings back to the factory default settings, follow the instructions below. If, for any reason, you desire to return all the stored
After all of the icons appear, release
the MODE and
DOWN buttons.
Then press and
hold the FAN
button for 5 seconds.
After the letters Fd appear on the
display (Factory
Default), release
the FAN button.
Press the MODE
button twice to return to normal
operation. Two dashes will appear
momentarily as the display resets.
FAN
Press
Press
MODE
MEMORY BACKUP - In the event of a power loss, the thermostat will retain
the stored program settings without external power or batteries.
PROGRAMMABLE FAN -
and the fan will run for the number of minutes selected in step #10
on page 14. This timer will start the fan at the top of each hour;
Page 17
Press button.
While holding the
MODE button,
press and hold
the DOWN button
for 5 seconds.
All of the icons will appear on
the display.
and hold the MODE
Place the
thermostat in
the OFF mode. Press
MODE
Press
MODE
88
88
H EAT
C OOL
OFF
AUTO
Fan On
Program
Locked
Setup On
o
o Am
Pm
I8 88
88
:
Day
Night
Evening
Morning
SuMTuWThFSa
OFF
Pm
I2 00 70
:
Su
OFF
Pm
I2 00 70
:
Su