Desa CGESBM - Manual (Page 6)

www.desatech.com 117191-01A 6
Figure 7 - Locating Flame Generation
Cylinder
Flame Cylinder
Drum (Half)
Figure 8 - Flame Generation Cylinder
Drum Bulb Replacement
CLEANING AND
MAINTENANCE
Continued
Replacing Flame Generation Bulbs
1. Remove the 6 screws from back of stove
shown in Figure 7. Remove back plate.
2. Locate the flame generation cylindrical drum.
It is constructed of two removable halves; ei-
ther of which can be removed from the unit.
3. Squeeze half of drum cylinder until it's top
edge clears the top drum track. Remove bot-
tom edge of cylinder drum from bottom drum
track. This will give you access to the light
bulbs. Note: Do not exert excessive pressure
on drum cylinder as this may cause damage.
4. Remove spring clip. Hold socket and pull out
old bulb.
5. Hold socket and push in new bulb (DO NOT
exceed wattage). Replace spring clip.
6. Repeat steps 4 and 5 for second bulb.
7. Insert bottom edge of removed cylinder half into
bottom drum track. Gently squeeze drum cylin-
der until it's top edge fits into top drum rack.
8. Secure the rear cover of the unit to the main frame
by reattaching screws removed in step 1.
9. Replace the log set ember bed.
10. Replace the grate to secure the log set.
11. Carefully replace front panel by sliding it
downward until the clips reconnect.
12. Replace the grill to front of unit using screws
removed earlier.
CLEANING FRONT PANEL GLASS
WARNING: When cleaning
unit, the power supply should
be disconnected and the unit
should be cool.
Over time the front glass panel may become dirty or
dusty. Dust can be removed by lightly rubbing the
glass surface with a clean, lint free cloth or paper
towel. To remove fingerprints or other marks, use
a damp cloth with a good quality household glass
cleaner. The front glass panel should be completely
dried with a clean, lint free cloth or paper towel.
CAUTION: Do not use abra-
sive cleaners on glass panel. Do
not spray liquids directly onto
any surface of the unit.
WARNING: An authorized
service representative should
perform any other servicing.
STORAGE
When not in use, unplug the unit from the power
supply and store in dry, dust free location.
Screws
Back
Plate
Bulbs with
Spring Clips
Back of Unit