Verilink T Lite (34-00292.2) Product Manual - Manual (Page 2)

ii
Copyright
Notice Copyright © 1999 Verilink Corporation. All rights reserved.
This document does not create any express or implied warranty about Verilink or about
its products or services. Verilink’s sole warranty is contained in its product warranty.
The end-user documentation is shipped with Verilink’s products and constitutes the
sole specifications referred to in the product warranty. Verilink has made reasonable
efforts to verify that the information contained herein is accurate, but Verilink assumes
no responsibility for its use or for any infringement of patents or other rights of third
parties that may result. The customer is solely responsible for verifying the suitability
of Verilink’s products for its use. Specifications are subject to change without notice.
Manual reorder # 34- 00292.2
2 nd Edition, April 1999
Trademarks Verilink is a registered trademark Verilink Corporation.
Any named products herein are trademarks of their respective companies.
FCC
Requirements This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user is required to correct the interference at his own expense. This device must also
accept any interference received, including interference that may cause undesired
operation.
For use only with a certified Class 2 power supply. See Power Source in
Specifications on page 10.
Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
1 This device may not cause harmful interference.
2 This device must accept any interference received, including interference that may
cause undesired operation.
Notice to
Users of
1.544 Mbps
Service
The following instructions are provided to ensure compliance with FCC Rules, Part 68.
1 All direct connections to T1 lines must be made using standard plugs and jacks.
2 The following information may be required by the local telephone company when
applying for leased line facilities:
3 If the unit appears to be malfunctioning, it should be disconnected from the
telephone lines until you learn whether the source of trouble is your equipment or
the telephone line. If your equipment needs repair, it should not be reconnected until
it is repaired.
4 The unit has been designed to prevent harm to the T1 network. If the telephone
company finds that the equipment is exceeding tolerable parameters, they can
temporarily disconnect service. In this case, the telephone company will give you
advance notice, if possible.
Port ID SOC FIC USOC Jack
1.544 Mbps (SF)
1.544 Mbps (SF) (B8ZS)
1.544 Mbps (ESF)
1.544 Mbps (ESF) (B8ZS) 6.0 N 04DU9-BN
04DU9-DN
04DU9-IKN
04DU9-ISN RJ-48C