VXL Instruments TC15yy 15 Series Thin client - Service Manual - Manual (Page 11)

Replacing Flash 7
4
Replacing Flash
To replace Flash:
1. Remove the power adapter, pedestal and side cover. For more information see, section
‘Removing the Pedestal and Side Cover’ on page 3.
Note: If the flash is fixed using glue, apply isopropyl alcohol on the glue holding the RAM,
pull the glue out using the nose pliers.
2. Gently pull the IDE flash up from the socket, as shown in Figure 7.
Figure 7: Flash
3. Place the new flash in the free socket and press it downwards.
Note:

Ensure that the new Flash is of the same dimensions as the previous one and has the
correct software image installed on it.

Use the hot glue gun to fix the Flash with glue.
4. Fix the top cover, pedestal and power adapter. For more information see, ‘Fixing ’ on page 4.