Wavecom EasySatSystem (W61PC) V1.2.00 - Manual (Page 9)

WAVECOM EasySat System Software V1.2 User Manual Software

5
In the EasySATSystem.ini file, one can also specify the sessions to exclusively be watched by listing the
respective MES Ids; if no MES Id is specified, then all sessions will be watched.
It is also possible to specify the duration (in seconds) of the automatic level setting (ALS) performed at
mode start-up. Only the first valid value specified will be used, if several are given in EasySATSystem.ini.
If desired, „EasySatSystem‟ collects statistical data concerning the monitored sessions. In such a case,
when exiting „EasySatSystem‟, a text file is stored in the directory <easysatsystem_data_dir> or in the di-
rectory specified by the environment variable EASYSATSYSTEM_DATA_DIR if it is set. The name of such a
file is „Stat<dateAndTime>.txt‟, where <dateAndTime> denotes the date and time (including seconds) of
the log-file creation, which occurs at the end of a monitoring session with „EasySatSystem‟. Be aware that
such a file may become quite large. To enable statistical logging a sampling interval (in seconds) greater
than 0 has to be specified in EasySATSystem.ini. Only the first valid value specified will be used, if several
are given in EasySATSystem.ini.
The name of the configuration file must be 'EasySATSystem.ini' (case-insensitive).
Below, the syntax of the configuration file is specified, for which the following rules apply:
 Whitespace (blanks, tabs) can be expanded to any length
 EOL means end-of-line
 means repetition 0 or more times
 Single superscript (e.g., xyz10) means repetition exactly the given number of times
 Range superscript (e.g., xyz1-9) means repetition with minimum and maximum bounds
 Bold words must appear exactly as shown
 | means alternative
 Terms in <…> are expanded
The starting point for the syntax is <config>.