Welltech LP-389 HTTP - Manual (Page 13)

Released Version 1.0 12
4. Provisioning Debug
If the provisioning has any problem, you can use the debug function from LP389 webpage. There
are two ways you can use. Please refer to the following steps to open the debug function. Enter your
LP389 web browser. Select the left function “Device Setting” at “Debug” to set. Then select
“emsclt” Debug Level : Debug.
Press button to complete setting.
Mode 1: Telnet
Step 1. Check your IP Phone network address
Step 2. Set up IP address of your computer which you are going to monitor debug messages. Both
the computer network address and IP Phone address should stay at the same subnet.
Step 3. Use Windows DOS command to login the LP389 IP Phone.