Westermo FD-80 - Manual (Page 12)

12 6630-2281
6.4.5 Ethernet network configuration by using Telnet
The FD-80 is always available for configuration of the TCP/IP protocol settings, by using
the Telnet network protocol. The default setting of FD-80 service port, for configuration
by using Telnet is:
IP-address 10.0.0.10 Subnet mask 255.0.0.0 Port number 1111
To select the configuration menu, start the Telnet client and use the parameters above,
e.g. under the DOS prompt enter Telnet <IP-address> 1111.
When the connection has been established you will see the following menu in your
Telnet window:
************************
* MINI Com-Server *
************************
1. INFO System
2. SETUP System
3. SETUP Port 0 (Serial)
4. Save Setup
Only one level at a time is shown on the monitor; enter a digit to scroll forward and
press ENTER to move backwards. All settings are activated only after a Save Setup. If
closing the Telnet connection without saving, the FD-80 retains all the settings it had
before opening the configuration menu. The following is an overview of the required
selections to be used by FD-80. The use of these selections are device and mode
dependent, to be described in chapters as follows:
FD-80 P Ethernet slave, Point to point continuously transfer mode See chapter 6.4.6
FD-80 P Ethernet slave, Point to point addressed mode See chapter 6.4.7
FD-80 A Ethernet master, addressed mode See chapter 6.4.8
6.4.5.1 Selections, used by FD-80
SETUP System > Setup TCP/IP
IP-Address
IP-address setting of FD-80.
Subnet Mask Subnet mask of the subnet in which the FD-80 is located.
Gateway IP-address of the Gateway, used to get connections from FD-80 to
other subnets.
SETUP Port 0 (Serial) > Port State
Connection State
Online control about the configured TCP/IP mode of the Ethernet
network connection. For access to FD-Tool it must be in mode
FREE, otherwise it has to be device and application dependent.
Clear Port Mode Revert the port to standard TCP/IP mode, FREE. This setting is
effective without Save Setup after exiting the menu.