Westermo MRD-330 - Manual (Page 27)

27 6623-2211
Under the ”DHCP Server Configuration table”:
• Set the ”Enabled” option to ”Yes”.
• Enter the first address of the group in the ”Start Address box”.
• Enter the last address of the group in the ”End Address box”.
• Enter a lease time for the ”Default Lease time”.
• Enter a lease time for the ”Maximum Lease time”.
• Click ”Update” to set the changes.
Figure 14
Configure clients to use the MRD-330
The MRD-330 will act as a gateway for connections destined over the wireless interface.
The default configuration will provide Network Address Translation and firewalling to
protect clients on the local network.
To configure clients to use the MRD-330 as their gateway:
• If the clients have a DHCP address allocated by the MRD-330, they will have learned
the necessary settings. No further configuration is needed.
• If clients have static IP addresses, set their default route and DNS server to the IP
address of the MRD-330.
Check to enable DHCP server
Set the DHCP IP address range
Set the DHCP default lease time
Set the DHCP max lease time
Click "Update" to save changes