AEC Self Cleaning Continuous Filters - Manual (Page 17)

Self Cleaning Continuous Filter Chapter 3: Installation 16
Note: Lifting lugs and spreader bar should be used for lifting Self Cleaning
Continuous Filter sections (See Figure 2 below).
Figure 2: Self Cleaning Continuous Filter Lifting Diagram
Note: Drawing may not depict current unit. Contact manufacturer’s
engineering department for current drawings.
3. Set hopper in place on support frame so that the inlet section is properly oriented with
respect to the inlet ductwork, and bolt hopper brackets to the support frame (See
Figure 3 on the next page). Apply two (2) beads of furnished caulking to the top
flange on the hopper (See Figure 4).