Airmar G2183 GPS - Manual (Page 7)

7
Cables & Connecting/Converting Hardware
The GPS Receiver (sensor) can be connected in several ways. You must have
the correct cable and any needed converting/connecting hardware before
beginning the installation.
Sensor Cables Length Part No.
• NMEA 0183 Cable 10m 33-862-02
• NMEA 2000® Cable 6m 33-1029-02
• NMEA 2000® Cable 10m 33-1029-06
NOTE: Additional cable lengths are available.
Connecting/Converting Hardware Length Part No.
• NMEA 0183 to USB, Data Converter 33-801-01
• NMEA 0183 to USB Combiner NDC-4-AIR
• NMEA 2000® CAN to USB, U200 Gateway 33-727-01
• NMEA 0183 & NMEA 2000® Splitter 15m 33-641-02
• NMEA 0183 & NMEA 2000® Splitter 30m 33-641-03
Tools & Materials
CAUTION: Vehicles/boats traveling above 30MPH—Do not use the plastic
Cable Side-exit Adaptor (part D) supplied. Purchase a stainless steel part. At high
speeds, the plastic adaptor may break, causing the sensor to fall off.
NOTE: The sensor has standard marine 1"-14 threads.
Pole/rail mounting hardware (some installations)
Safety goggles
Dust mask
Screwdrivers (Pole/Rail Mount installation)
Teflon pipe thread tape, 1/2" wide (some installations)
Pencil (some installations)
Electric drill (some installations)
Drill bits and hole saws (some installations):
Pilot hole 3mm or 1/8"
Flush mount stud holes 6mm or 1/4"
Flush mount cable hole 38mm or 1-1/2"
Loctite® 242® or other removable thread locker (Flush Mount installation)
Grommets (some installations)
Cutting pliers (some installations)
Heat-shrink tubing (some installations)
Heat gun (some installations)
Wire strippers (some installations)
Multimeter (some installations)
Cable ties (some installations)