EverFocus Day / Night Speed Dome Camera EPTZ 100 User Manual
Page 30
EPTZ100_ma_en_rev03.doc
30
SPECIAL
Submenu for advanced camera functions:
USER PRESET
Not supported by EPTZ 100
PRIVACY
Keep OFF setting, privacy mask setup is done in the
PRIVACY MASK menu, available in the main menu
DAY/NIGHT
Modes of the day/night switching:
B/W : black/white (night) mode, IR cut filter switched off
COLOUR: colour (day) mode, IR cut filter switched on
AUTO1: day/night switching with short delay time
AUTO2: day/night switching with longer delay time
SYNC:
Synchronization mode, fixed at INTERNAL mode
COMM ADJ
Communication settings for camera interface
ATTENTION:
Do not change any value in this submenu!
Keep
default
settings:
CAM ID
0
DISP
CAM
ID
OFF
BAUD
RATE
38400
UART
MODE
8-N-1
RET PKT
ENABLE
If these settings are changed for whatever reason, the
communication between dome electronics and camera
menu will be broken. In this case consult APPENDIX C
for recovering camera module communication settings.
IMAGE ADJ
FREEZE: Store ("freeze") current video image
H-REV: Flips the image horizontally
V-REV: Flips the image vertically
SHARPNESS: Image sharpness adjustment in the range
1
~
30
COLOUR GAIN: Colour saturation adjustment in the
range
1~
50
END
Return to CAMERA ADVANCED SETTING page
RESET
Reset of the camera parameters to factory defaults.
EXIT
Return to CAMERA menu.