Amped Wireless AP300 - High Power Wireless-300N Smart Access Point - Manual

1
2
1
Connect the Smart Access Point to your Router
Optional Configurations: Accessing the Settings Menu
Connect your Computer to the Smart Access Point
Note: If your network uses static IP address assignments, you will need to manually configure the settings for your
Smart Access Point. See the instructions on the back to access the configuration menu of the Access Point.
The instructions below are optional. You may now use your Smart Access Point without any additional
configurations. However, if you wish to change any settings (such as network ID and security) for the
Smart Access Point, follow the instructions below to access the configuration menu of the Access Point.
!
7
Setup Summary
Open your Web Browser
If the URL fails to open, then try: http://192.168.1.240
http://setup.ampedwireless.com
Enter the setup web address into your browser:
2
6
Wireless Network Security
The default Security Key (WPA) of your
wireless network is:
wireless
To change it, enter a new key in the Secu-
rity Key field. The key must be at least 8
characters long.
Click Next to apply your settings.
The Smart Access Point will reboot. This
process may take up to 2 minutes. The page
will automatically reload after the count-
down. If it does not, you may need to
reconnect to the Access Point and refresh
the page manually.
Connect to
Network Port
Internet Modem Router
(LAN Port)
Wired Connections: Wireless Connections:
Scan for available wireless networks on your
PC and connect to the following network:
Attach any Wired Devices to the
Smart Access Point using an
Ethernet cable.
NETWORK ID: Amped_AP
PASSWORD: wireless
3
Welcome to the Smart Setup Wizard
The wizard will guide you through the
setup of your:
1) System Clock
2) Wireless Network SSID
3) Wireless Network Security Key
Click Start to begin.
1
2
3
4
Set the System Clock Time
The System Clock is used for system logs
and setting schedules for Internet access.
Click
Sync to synchronize the System Clock
with the time on your computer.
Click Next to continue.
The Setup Summary provides you with
information regarding your current settings.
If you have wired network devices, you may
attach them to the wired ports on the back
of the Smart Access Point for additional
wired connectivity.
If you have any questions during the setup process
please contact Amped Wireless support department:
Phone: 888-573-8820
Email: [email protected]
Web: www.ampedwireless.com/support
Scan for available wireless networks on your
PC and connect to the following network:
The ID of your Wireless Network is:
Amped_AP
To change it, enter a new name in the SSID
field. Users connecting wirelessly to the
Access Point will use this ID to identify your
wireless network.
Click Next to continue.
5
Wireless Network ID
Congratulations, you’re done!
NETWORK ID: Amped_AP
PASSWORD: wireless
Do NOT use an Ethernet cable when accessing the setup menu.
!
— R E A D F I R S T —
Need Help? Give us a call.
Phone: 888-573-8820
Email: [email protected]
Web: www.ampedwireless.com/support
?
SETUP GUIDE
AP300
High Power Wireless-300N Smart Access Point
Connect the Smart Access Point
to your Router’s Network (LAN)
port, or a network switch.
Network
Plug in the Power Adapter
Attach the Antennas
Allow up to two (2) minutes for the
Smart Access Point to automatically
configure itself to your network
Amped_AP
If you have any questions regarding this product, then give us a call we’re here to help: 888-573-8820