Aqua Lung Dimension i3 / Lotus i3 BC - Manual (Page 29)

English
© 2012 Aqua Lung International
BC
Home
INFLATION METHODS USING THE I3 SYSTEM
Your BC uses the i3 Inflation and deflation system. This may be different than the inflation / deflation systems
that you are familiar with. The i3 system simplifies buoyancy control by locating inflation and deflation control
in one location. It is very important to read the following instructions, and become thoroughly familiar with the
correct methods for inflating and deflating your BC using the i3 system.
NOTE: The Airsource or Powerline inflator may also be added to any BC using the i3 inflation
system. Simply remove the oral inflator and replace it with either the Airsource or Powerline.
POWER INFLATION WITH THE I3 CONTROL UNIT
For the power inflator to operate, the MP inflator hose must be connected (see “Routing and Attaching the
MP Inflator Hose”). After the hose is attached to the i3 Control Unit, pressurize the first stage regulator by
slowly opening the cylinder valve.
To inflate your BC with air, lift up on the lever
of the i3 Control Unit. Do not hold the lever up
continuously underwater, as this could cause
you to become excessively buoyant. Instead,
inflate the BC in short bursts until you become
neutrally buoyant.
WARNING: Do not rely on the i3 Control Unit as the only means to inflate your BC. It is
important to practice the technique for orally inflating your BC so that you are prepared
for any type of malfunction or out of air situation that could render the i3 Control Unit
inoperable. You may otherwise be unable to achieve positive buoyancy in an emergency,
which could lead to serious injury or death.
WARNING: Avoid using excessive torque when lifting the lever of the i3 Control Unit.