ARM Electronics ARM HR Series - Manual (Page 7)

7
16CH:
• To set up dome camera’s protocol and ID, press MENU to access the OSD main menu, and
select <Camera Setup>. Then select <Dome Protocol> and choose the corresponding
protocol. Next select <Dome ID> and choose a preferred ID number. Note that the ID number
must match the ID address defined by the dome camera.
• To configure the RS-485 parameters, select <System Setup> from OSD main menu, and then
select <RS485 Setup>. The default RS-485 settings are 9600 Baud, 8 Data Bits, 1 Stop Bit and
No Parity.
Control Buttons in Dome Camera Control Mode:
1
Set / Go Preset
5
Pan / Tilt
9
Iris Close
2 Go Presets 1~6 6
Enter Dome Camera
Control Mode
10 Iris Open
3 Enter / Auto 7 Focus Near 11 Zoom Out
4
ESC
8
Focus Far
12
Zoom In