Eneo PXD-2030PTZ1080 - Manual (Page 7)

6
2. Camera Cabling
Follow the instructions below to complete IP Camera connection.
2.1 Connect Power
Refer to the illustration and the pin definition table below to connect the power
core through the supplied power adaptor to the camera.
2.2 Connect Ethernet Cable
Use of Category 5 Ethernet Cable is recommended for network connection;
to have best transmission quality, cable length shall not exceed 100 meters.
Connect one end of the Ethernet Cable to the camera’s RJ-45 connector,
and plug the other end of the cable to the network switch or PC.
NOTE: In some cases, Ethernet Crossover Cable might be needed
when connecting the camera to the PC.
Check the status of the link indicator and activity indicator LEDs. If the LEDs are
unlit, please check the LAN connection.
Green Link Light indicates good network connection.
Orange Activity Light flashes for network activity indication.
Pin Definition
1 AC 24_1
2 FG
3 AC 24_2