Ensemble Designs 6020 Four Channel 24-bit Audio DAC - Manual (Page 5)

Model 6020 Four Channel 20-bit Audio DAC
6020-5
INSTALLATION
Plug the 6020 module into any one of the ten slots in the frame and install the plastic
overlay provided onto the corresponding group of rear BNC connectors associated with the
module location. Note that the plastic overlay has an optional adhesive backing for
securing it to the frame. Use of the adhesive backing is only necessary if you would like
the location to be permanent and is not recommended if you need to change module
locations. This module may be hot-swapped (inserted or removed) without powering down
or disturbing performance of the other modules in the system.
CABLING
Refer to the backplane diagram of the module below for cabling instructions.
Connect an AES
input signal to the
AES In 1/2 BNC.
Connect the 15-pin
high-density Audio Out
connector to an analog
audio destination.
Refer to the pinout
diagram below.
Connect an AES
input signal to the
AES In 3/4 BNC.
Connect Mon 1-4
BNCs to to single-
ended analog
monitor outputs.
1
6
+
+
+
+
-
-
-
-
11
CH 2 CH 1
CH 3 CH 4
6020 Wiring to Frame
15-pin D Male Connector
Wiring Side-Male Plug