H3C Technologies H3C S10500 Series Switches - Manual (Page 449)

434
Task Remarks
Configuring IPv6 MBGP route preferences
Configuring the default local preference
Configuring the MED attribute
Optional
Configuring the next_hop attribute Optional
Configuring IPv6
MBGP route
attributes
Configuring the as_path attribute Optional
Configuring IPv6 MBGP soft reset Optional
Enabling the IPv6 MBGP orf capability Optional
Tuning and
optimizing IPv6
MBGP networks Configuring the maximum number of equal-cost routes for
load-balancing
Optional
Configuring an IPv6 MBGP peer group Optional
Configuring IPv6 MBGP community Optional
Configuring a large
scale IPv6 MBGP
network
Configuring an IPv6 MBGP route reflector Optional
Configuring IPv6 MBGP basic functions
Configuration prerequisites
IPv6 MBGP is an application of multiprotocol BGP. Before you configure IPv6 MBGP, complete the
following tasks:
• Enable IPv6
• Configure network layer addresses for interfaces
• Complete BGP basic configuration
Configuring an IPv6 MBGP peer
Follow these steps to configure an IPv6 MBGP peer
To do… Use the command… Remarks
Enter system view system-view —
Enable BGP and enter BGP view bgp as-number
Required
Not enabled by default.
Enter IPv6 address family view ipv6-family —
Specify a IPv6 BGP peer and its AS
number peer ipv6-address as-number
as-number Required
Not configured by default.
Enter IPv6 MBGP address family view ipv6-family multicast —
Enable the IPv6 MBGP peer peer ipv6-address enable
Required
Not enabled by default.