H3C Technologies H3C S3100V2 Series Switches User Manual
Page 29
23
Figure 29 Mount the switch to the rack by using front and rear mounting brackets
1 2
3
4
5
6
(1) Load-bearing screw
(2) Rear mounting bracket
(3) Switch front panel
(4) M6 screw for fix the front mounting bracket to the rack
(5) Front mounting bracket
(6) Front rack post
Rack mounting by using front mounting brackets and slide rails
Follow these steps to mount the switch to the rack by using front mounting brackets and slide rails:
Step1
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well grounded,
check that the rack is sturdy and well grounded.
Step2
Unpack the screws (packed with the front mounting brackets), and install the mounting brackets to the
switch with the screws, as shown in
.
Step3
Plan the position of the switch in the rack. Install the slide rails by using M5 tapping screws to the
corresponding positions on the rack posts, as shown in
.
Step4
Install the cage nuts to the corresponding positions on the rack posts.