H3C Technologies H3C SR8800 - Manual (Page 38)

26
Step Command Remarks
4. Configure the destination
address of probe packets.
destination ip ip-address
By default, no destination IP
address is configured.
5. Configure the source IP
address of probe packets.
source ip ip-address
Optional.
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface. The
local interface must be up;
otherwise, no probe packets can
be sent out.
6. Configure optional
parameters.
See “ Configuring optional
parameters for an NQA test
group
”
Optional.
Configuring the collaboration function
Collaboration is implemented by establishing reaction entries to monitor the detection results of a test
group. If the number of consecutive probe failures reaches the threshold, the configured action is
triggered.
To configure the collaboration function:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter NQA test group view.
nqa entry admin-name
operation-tag
N/A
3. Enter test type view of the test
group.
type { dhcp | dlsw | dns | ftp |
http | icmp-echo | snmp | tcp |
udp-echo }
The collaboration function is not
supported in UDP jitter and voice
tests.
4. Configure a reaction entry.
reaction item-number
checked-element probe-fail
threshold-type consecutive
consecutive-occurrences
action-type trigger-only
Not created by default.
You cannot modify the content of
an existing reaction entry.
5. Exit to system view. quit N/A
6. Configure a track entry and
associate it with the reaction
entry of the NQA test group.
track entry-number nqa entry
admin-name operation-tag
reaction item-number
Not created by default.
Configuring threshold monitoring
Configuration prerequisites
Before you configure threshold monitoring, complete the following tasks: