H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 14)

8
Installation flow
Figure 3 Installation flow
Mounting the device on a workbench
If a standard 19-inch rack is not available, you can place a device on a clean, flat workbench, as follows:
1. Clean the recessed areas on the chassis bottom.
2. Attach the four rubber feet to the recessed areas on the chassis bottom.
3. Place the device on the workbench.
IMPORTANT:
Avoid placing heavy objects on the device.
Install the device
Install the device to a
19-inch rack
Mount the device to a
workbench
Ground the device
Install a lightning protector
for a network port (optional)
Connect interface
cables
Connect the power cord
Power on the device
Operating
correctly?
Yes
End
No
Power off the device
Troubleshoot the device
Start
Install the power module
Connect AC power supply
to power strip with lightning
protection (optional)