H3C Technologies H3C SecBlade SSL VPN Cards - Manual (Page 27)

21
Menu item Description
<5> Modify BootWare Password Modify the BootWare password.
<6> Skip Current System
Configuration
Ignore the current system configuration.
The operation is one-off valid for the current boot. If you want the
SecBlade card to ignore the current configuration at the next boot, you
need to perform this operation.
<7> BootWare Operation Menu
Enter the BootWare operation submenu.
For more information, see “
BootWare Operation Submenu ” on
page 23 .
<8> Clear Super Password
Clear the super user password.
The super user password is required in user level switching.
By default, no super user password is set.
The setting is valid only for the first reboot of the SecBlade card and the
super user password will be restored next time the SecBlade card
reboots.
<9> Storage Device Operation
Enter the storage device operation submenu to select applications
from a storage device to boot the SecBlade card.
<0> Reboot Reboot the SecBlade card.
Serial Submenu
Select 2 on the main menu to enter the serial submenu, where you can upgrade applications using
Xmodem. The serial submenu is as follows:
======================<SERIAL SUB-MENU>======================
|Note:the operating device is cfa0 |
| <1> Download Application Program To SDRAM And Run |
| <2> Update Main Application File |
| <3> Update Backup Application File |
| <4> Update Secure Application File |
| <5> Modify Serial Interface Parameter |
| <0> Exit To Main Menu |
=============================================================
Enter your choice(0-5):
Table 9 describes the serial submenu items.
Table 9 Serial submenu
Submenu item Description
<1> Download Application Program To
SDRAM And Run
Download an application to the SDRAM through the serial
interface and run the application.
<2> Update Main Application File Upgrade the main application file.
<3> Update Backup Application File Upgrade the backup application file.
<4> Update Secure Application File Upgrade the secure application file.
<5> Modify Serial Interface Parameter Modify the serial interface parameters.