H3C Technologies H3C SecBlade SSL VPN Cards - Manual (Page 49)

43
NOTE:
•
If you enter the old BootWare password incorrectly, “Wrong password, Please input password again:”
appears.
• After three attempts to enter the correct old BootWare password, “Wrong password, system halt.”
appears and the SecBlade card halts.
3. Enter a new BootWare password twice at the prompt.
Please input new password: ******
Please input new password again: ******
If the following information appears, the BootWare password is successfully modified.
Password Set Successfully.
Super Password Loss
The super password enables you to switch between four super levels. If you forget the super password,
you are unable to perform higher level operations.
Follow these steps to bypass the super password:
1. Select 8 on the main menu to clear the super password.
==================<EXTEND-BOOTWARE MENU>=====================
| <1> Boot System |
| <2> Enter Serial SubMenu |
| <3> Enter Ethernet SubMenu |
| <4> File Control |
| <5> Modify BootWare Password |
| <6> Skip Current System Configuration |
| <7> BootWare Operation Menu |
| <8> Clear Super Password |
| <9> Storage Device Operation |
| <0> Reboot |
=============================================================
Enter your choice(0-9):8
If the following information appears, the super password is successfully cleared.
Clear Application Password Success
2. Exit from the main menu and reboot the SecBlade card to directly enter the system view.
NOTE:
This setting works only once. The super password will be restored when the SecBlade card is rebooted for
a second time.