Ipv4 netstream configuration, Ipv4 netstream configuration task list – H3C Technologies H3C SecBlade NetStream Cards User Manual
Page 159
144
IPv4 NetStream configuration
This chapter includes these sections:
•
IPv4 NetStream configuration task list
•
Displaying and maintaining IPv4 NetStream
IPv4 NetStream configuration task list
Before you configure IPv4 NetStream, determine the following proper configurations as needed.
•
Make sure on which device you want to enable IPv4 NetStream.
•
If multiple service flows are passing the NDE, use an ACL to select the target data.
•
If enormous traffic flows are on the network, and sampling is configured on the device where the
SecBlade NetStream card resides, configure IPv4 NetStream sampling.
•
Decide which export format is used for IPv4 NetStream data export.
•
Configure the timer for IPv4 NetStream flow aging.
•
To reduce the bandwidth consumption of IPv4 NetStream data export, configure IPv4 NetStream
aggregation.
Figure 47 NetStream configuration flow