H3C Technologies H3C Intelligent Management Center - Manual (Page 56)

6-12
MIB management function to view the information. To do so, log
in to the iMC and then enter the system management page.
Figure 6-17 Table view by using the iMC MIB management tool
7) Click the Add Module button ( ) in the work area, and then
drag the added virtual module entity to slot 0, and modify its
properties. Note: Set rotating angle to 90, because the modules
we drew are horizontal. Set the relative position to 0.1, which is
consistent with that implemented in the device entPhysicalTable.
The S12518 device is represented in the form of
Stack->Chassis->Container->Module, where Container
indicates the module slot. As introduced previously, the
entPhysicalParentRelPos node represents the relative position
of an entity on its parent entity. The container here means the
slot number. Usually, only one module is contained in one slot,
and thus the relative position of a module to a container is always
1. The relative position 0.1 here indicates module 1 in slot 0. This