Grass Valley 2041EDA - Manual (Page 10)

10 2041EDA Instruction Manual
Power Up
Power Up
The on-board LED indicators are illustrated in Figure 3 . Upon power-up,
the green PWR LED should light and the yellow CONF LED should illumi-
nate for the duration of module initialization.
Operation Indicator LEDs
With a valid input signal connected, the green on-board PWR LED,
SIG_PRES LED and the SIG LED (visible from the rear) should be on. Refer
to
Table 1 on page 11 to see a complete list of possible operating conditions
and the resulting indicator status.
Figure 3. LEDs and Configuration Switches
8032_03
F1
FAULT
Fault – (red) off during normal operation
Communication – (yellow)
Configuration – (yellow)
Power – (green) on during normal operation
Remote override – (yellow)
Signal present – (green)
COMM
CONF
PWR
SIG_PRES
Signal present – (green) on rear connector plate