Grass Valley 2041RDA - Manual (Page 11)

2041RDA Instruction Manual 11
Power Up
Power Up
The front LED indicators and configuration switches are illustrated in
Figure 4 . Upon power-up, the green PWR LED should light and the yellow
CONF LED should illuminate for the duration of module initialization.
Operation Indicator LEDs
With factory default configuration and a valid input signal connected, the
green PWR LED, the green Signal present LED and the detected signal data
rate LED should be on. Refer to
Table 1 on page 12 to see a complete list of
possible operating conditions and the resulting indicator status.
Figure 4. 2041RDA Status LEDs
8025_01
FAULT
Fault – (red) off during normal operation
Communication – (yellow)
Configuration – (yellow)
Power – (green) on during normal operation
Remote override – (yellow)
Signal present – (green)
Reclocking mode – (yellow )
COMM
CONF
PWR
REMOVR
SIG_PRES
RECLOCK
Signal present – (green) on rear connector plate