Grass Valley 3-CCD CameraMan - Manual (Page 25)

CameraMan Installation and Operation Manual 25
Section
4
System Startup
Note Before powering the CameraMan system, ensure all necessary connections
and configurations are complete
1. Just switch the Power button on the back of the CameraMan DIGITAL
Camera to the ON position. The Camera should automatically enter its
position calibration mode and then stop at the zero degree point.
2. Verify that the camera is now facing in the direction the “FRONT” label
was pointing during mounting.
3. If you are using the Camera Control Keypad or DIGITAL SHOT
Director, make sure its base unit address is the same as on the camera.
If they are, verify that the camera’s PAN and TILT functions are
working properly.