Center control switches, Switch bank b, Tally light interface port – Grass Valley 3e CameraMan User Manual
Page 19
CameraMan 3e 3-CCD Camera Overview
CameraMan 3e 3-CCD Camera Installation and Operations Manual
11
Center Control Switches
Switch Bank B
Tally Light Interface Port
Provides output and external control for Camera-
Man Tally Light.
Video Select Switch
Used to set the video source to Composite (down)
or S-Video (up). Cannot be used simultaneously.
Base Unit Address
Used to configure the address of the Camera.
Switch 1
(Protocol Select Switch)
Used to select the type of Protocol being used for
RS-232 and RS-485 communications. This can be
configured as either Basic or High Reliability.
Switch 4
(RF Commands Switch)
Used to enable or disable the RF Receiver in the
CameraMan camera.
Switch 5
(Preset Save)
Used to determine how the preset settings will be
saved.
Switch 8
(Interlink Switch
Used to disable commands from being sent on the
RS-485 bus to other CameraMan devices.
Switches 2, 3, 6, 7
Reserved for future use.