Panel setup mode, Bed on – Grass Valley Jupiter v.1.0 User Manual
Page 106

106
Jupiter L-S Series Control Panels Installation and Operating Manual
Appendix B — Front-Panel Service Modes
Application Version, ReLoader Version
V:xx.yyy.zzz
B: nn
...where
xx = the major release number,
yyy = the minor release number,
zzz = the documentation number, and
nn = the build number.
FPGA Image Version
Image: User
V:xxx.yyyyy
Panel ID
•
HW: (hardware number of the panel)
•
Type of Panel (e.g. L32)
Pri. Net 1 GW, Sec. Net2 GW,
•
Primary and Secondary Gateway addresses
Pri. Net 1 SN, Sec. Net2 SN
•
Primary and Secondary Subnet Masks
Pri. Net 1 IP, Sec. Net2 IP
•
Primary and Secondary ID Addresses
MAC-1, MAC-2
•
Network 1 and 2 MAC Addresses
Pri. Host IP, Sec. Host IP
•
Primary and Secondary Jupiter CM4000 IPs
Panel Setup Mode
Panel setup mode is used for service and troubleshooting only.
Change ID Procedure
1.
Access Panel Setup mode.