Grass Valley Jupiter v.1.0 - Manual (Page 48)

48 Jupiter L-S Series Control Panels Installation and Operating Manual
Section 3 — Software Installation & IP Addresses
must be set correctly before L-S panel software can be updated. See Setting
IP Addresses on L-S Panels on page 45 for more information.
1. Launch NetConfig.
Note If NetConfig is already installed you can Cancel its installation.
2. Click on the Load Software tab at the top of the NetConfig screen. The
software load window will open ( Figure 25 ).
Figure 25. L-S Panels Installation Welcome Screen
3. Navigate to the Jupiter/Panels folder in the left pane and select the type
of panel whose software you wish to update.
4. Select the specific panel(s) in the right pane you wish to update.
5. Ensure the Re-Boot when complete box on the lower right is checked.
6. Click Load . The software will be loaded to the selected panels and the
panels will reboot.