Grass Valley K2 Dyno Replay Controller - Manual (Page 49)

June 16, 2009 K2 Dyno Replay Controller Service Manual 49
Windows startup
Windows startup
After the BIOS startup processes complete the Windows operating system starts up.
Normally the Windows operating system completes its processes automatically
without the need to press keys or respond to messages.
If the Windows startup screen does not proceed automatically or if a message appears
that requires your input, it indicates a problem at the operating system level. If the
problem cannot be corrected with a supported procedure (such as networking), the
Windows operating system is not operating as it should. To correct problems of this
nature, restore the system drive image. Refer to
“Using recovery disk images” on
page 37 .