Grass Valley K2 10G RAID - Manual (Page 42)

18 November 2010 K2 10G RAID Storage Instruction Manual
42
Installing the rack mounts
3. Remove the rack brackets from the guide brackets at both ends of the rail. Save the
rack brackets and the M3 screws, as they are used later in this procedure.
4. Proceed as follows:
• If your rack has 10-32 threaded holes, skip the next step.
• If your rack has 0.281-inch round holes, proceed with the next step.
5. For a rack with 0.281-inch round holes, at both ends of the rail replace the T type
guide brackets with the H type guide brackets.
Left rail
Right rail
Label
Front
Rear
Rack Bracket and
Guide Bracket for
threaded screws are
mounted at each end
of the rail
Left rail
Screw
Screw
Rack Bracket