Grass Valley K2 Media Client User Manual v3.3 - Manual (Page 102)

102 K2 Media Client User Manual June 5, 2009
Chapter 6 Working with playlists
Editing and rearranging events in a playlist
The following topics explain how to work with events in a playlist:
• “Editing event marks” on page 102
• “Moving events” on page 103
• “Removing events” on page 103
• “Copying events” on page 103
• “Renaming events” on page 103
• “Locating the event source clip” on page 103
• “Viewing event properties” on page 104
Editing event marks
You cannot edit events while the list is playing. Every event has a event-in point and
an event-out point that refer to the first and last frames displayed when the event
plays. When first created, event marks are set to the mark-in and mark-out of the
source clip. You can edit the event marks in order to reference only the desired media.
The following restrictions apply when editing event marks:
• Event-in must precede the Event-out.
• Event marks cannot be set outside the recorded media of the source clip.
NOTE: If more media exists outside the current mark, a <<< or >>> symbol is
displayed beneath the current event mark timecode.
Setting the Event In/Out marks
To move clip marks:
1. Use the transport controls to locate the desired frame.
2. Select Playlist | Set Event In to set mark-in point or Playlist | Set Event Out to set
mark-out point. The Confirm Marks dialog box opens.
3. Click Yes to accept the edited mark.
Modifying the Event In/Out marks
To modify event marks:
1. Select the event you are modifying.
2. Open the properties dialog box by doing one of the following:
• Select Playlist | Properties .
• Click the Properties button.
3. Click the General tab.
4. Select the Event In, Event Out, or Length edit control and do one of the following:
• To modify marks, enter the timecode value to specify mark locations.